Friedrich UE08, UE12 Installation Requirements, Installation Hardware, Electrical Service

Installation

Remove packing sheet from the back of the sleeve, and packing corner and blue tape from the air conditioner.

INSTALLATION REQUIREMENTS

If you use an existing wall sleeve, you should measure its dimensions.

Install the new air conditioner according to these installation instructions to achieve the best performance. All wall sleeves used to mount the new air conditioner must be in good structural condition and have a rear grille to securely attach the new air conditioner. (FIG. 1) Installing the FRIEDRICH USC sleeve ensures optimal performance of the new air conditioner. (FIG. 2)

19-21/32"

(499 mm)24-21/32"

(626 mm)

INSTALLATION HARDWARE

1		2
		4
		2 Size options	9
	7	5
8		3
		6
		2 Size options

ITEM	NAME OF PARTS	Q'TY
1	PLASTIC GRILLE	1
2	HORIZONTAL INSULATION STRIPS	2
3	AROUND INSULATION STRIPS	2

Air Conditioner

14-13/32"

(366 mm)

18"(458 mm)

FIG. 1

4	SUPPORT BLOCK	2
5	BAFFLE	1
6	TRIM FRAME	2
7	SHIM	2
8	PLASTIC NUTS AND WASHER SCREWS	4
9	GRILLE REAR	1

CAUTION

aluminum metal grille

25-7/8"

(656 mm)

15-17/32"

(394 mm)

16-23/32"

(425 mm)

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed:

• Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people

are needed to move and install the unit.

To prevent injury or strain, use proper lifting and

carrying techniques when moving unit.

• Carefully inspect location where air conditioner

Parts

FRIEDRICH Wall Sleeve FIG. 2

ELECTRICAL SERVICE

Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on left side of cabinet).

All models are equipped with a 3-prong service plug to provide proper service and safe positive grounding. Do not change plug in any way. Do not use an adapter plug. If your present wall outlet does not match your plug, call a qualified electrician to make the necessary corrections. SAVE CARTON for storage and this OWNER'S MANUAL for future reference. The carton is the best way to store unit during winter or when not in use.

will be installed. Be sure it will support the weight

of the unit over an extended period of time.

• Handle air conditioner with care. Wear

protective gloves whenever lifting or carrying the

unit. AVOID the sharp metal fins of front and

rear coils.

• Make sure air conditioner does not fall during

installation.

REQUIRED TOOLS:

• Tight Fitting gloves	• 3/8-inch open end
• Standard screwdriver	wrench or adjustable
	wrench
• Phillips screwdriver
	• 1/4-inch hex socket
• Pliers
	and ratchet
• Sharp knife
	• Tape measure
	• Electric drill
	• 1/4-inch drill bit

and Installation

11