Friedrich UE08, UE12 Electrical Data, Electrical Safety, 115V~, 230V~, Use Of Extension Cords

Electrical Data

Electrical Data

115V~

230V~

Power cord may include a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

Electrical

USE OF EXTENSION CORDS

Because of potential safety hazards, do not use an extension cord.

Use Wall Receptacle		Power Supply
	Standard 125V,
	3-wire grounding
	receptacle rated	Use 15 AMP. time
	15A, 125V AC
		delay fuse or 15 AMP.
	Standard 250V,	circuit breaker.
	3-wire grounding
	receptacle rated
	15A, 250V AC
	Standard 250V,	Use 20 AMP. time
	3-wire grounding
		delay fuse or 20 AMP.
	receptacle rated
		circuit breaker.
	20A, 250V AC

Electrical Shock Hazard

Plug into a grounded 3 prong outlet. Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Data

All wiring should be done in accordance with local electrical codes and regulations.

NOTE : Aluminum house wiring may pose special problems. Consult a qualified electrician.

■ ELECTRICAL SAFETY

IMPORTANT GROUNDING INSTRUCTIONS

The air conditioner has a three-prong grounding plug on its power supply cord, which must be plugged into properly grounded three-prong wall receptacle for your protection against possible shock.

FUSE – Use a time-delay fuse or circuit breaker. Refer to the nameplate for proper power supply requirements.

208/230 VOLT UNITS

These units are equipped with a three-prong grounding plug on the power supply cord, which must be plugged in to a matching, properly grounded three-prong wall receptacle for your protection against possible shock hazard. If such an outlet is not present, one must be installed by a qualified electrician in accordance with the National Electrical Code and local codes and ordinances.

5