Frigidaire FGES3065PF manual Effortless Oven Rack system, Before Setting Oven Controls

BEFORE SETTING OVEN CONTROLS

Effortless™ Oven Rack system

Some models are equipped with a special oven rack system that automatically extends the oven rack to assist in access to your food items. This rack extends when the oven door is opened or closed.

CAUTION

Remove all oven racks and accessories before starting a self-clean cycle. If the oven racks are left in the oven during the self-clean cycle, the gliding ability of the Effort- less™ Oven Rack system will be damaged, and oven racks will loose their shiny finish and may turn blue. Remove all oven racks and clean according to instruc- tions provided in the Care & Cleaning section of this manual.

Make sure the oven and oven racks are completely cool before attempting to assemble or disassemble the Effort- less™ Oven Rack system. Never pick up hot oven racks or parts.

To assemble the Effortless™ Oven Rack system:

1.Locate all required parts. You will need the supplied oven rack (Effortless™ Oven Rack is a flat rack with a special dark coating on the left and right rack sides) and the two supplied chrome connector arms.

2.Open the oven door. Be sure the oven is completely cool before proceeding.

3.Place the oven rack in positions 2, 3, or 4 only. Be sure the rack connector brackets are at the rear of the range and pointing towards oven bottom (See Figure 16).

rack connector bracket

Figure 16: Bracket must be at rear of the range

4.Assemble one connector arm at a time. With the oven door open and the oven rack in place, install one end of the connector arm to the hole in the door connector bracket (Figure 17) and the other end in the hole in the rack connector bracket (Figure 18). The oven rack may need to be adjusted in or out in the rack position to match the length of the connector arm.

door connector bracket

Figure 17: Connector arm/door connection

5.While holding the connector arm in place, twist the connector arm so the ends of the connector arm point upwards (Figure 19). The connector arm should now be locked into position.

6.Repeat steps 4 and 5 for the other connector arm.

7.Once both connector arms are properly in place, be sure to test the oven rack operation by gently closing the oven door. The oven rack should move in and out of the oven freely when the door is opened or closed.

connector	oven
arm
	rack

open oven	connector
	arm
door

Figure 18: Assembly of the Effortless™ oven rack

21