Manuals / Frigidaire / Kitchen Appliance / Range

Frigidaire FGES3065PF Setting the Clock, Setting 12 or 24 Hour Time of Day Display, Oven Controls

Models: FGES3065PF

1 55

Download 55 pages 53.82 Kb

Page 24

Table 3: Minimum and maximum control settings

OVEN CONTROLS

Table 3: Minimum and maximum control settings
Feature		Mode		Minimum Temp. /Time		Maximum Temp. /Time
Feature		Mode		Minimum Temp. /Time		Maximum Temp. /Time

Preheat				170°F (77°C)		550°F (288°C)

Bake				170°F (77°C)		550°F (288°C)

Broil				400°F (205°C)		550°F (288°C)

Convection Bake				170°F (77°C)		550°F (288°C)

Convection Roast				170°F (77°C)		550°F (288°C)

Convection Broil				400°F (205°C)		550°F (288°C)

Slow Cook				Lo 225°F (108°C)		Hi 275°F (135°C)

Meat Probe				Lo 140°F (60°C)		Hi 210°F (99°C)

Timer		12 Hr. Mode		0:01 Min.		11:59 Hr./Min.
		24 Hr. Mode		0:01 Min		11:59 Hr./Min.

Clock Time		12 Hr. Mode		1:00 Hr./Min.		12:59 Hr./Min.
		24 Hr. Mode		0:00 Min		23:59 Hr./Min.

Delay Start		12 Hr. Mode		1:00 Hr./Min.		12:59 Hr./Min.
		24 Hr. Mode		0:00 Min		23:59 Hr./Min

Bake Time		12 Hr. Mode		0:01 Min		5:59 Hr./Min.
		24 Hr. Mode		0:01 Min		5:59 Hr./Min.

Self Clean Time				2 hours		4 hours

The features listed show the minimum and maximum time or temperature settings allowable.

Setting the Clock

The set clock control is used to set the clock. The clock may be set for 12 or 24 hours display operation. The clock is preset at the factory for 12 hour display. When the oven is first plugged in, or when the power supply to the oven has been interrupted, the timer in the display will flash.

To set the clock (example below for 1:30):

1.Press set clock. CLO will appear in the display.

2.Press 1 3 0 on the keypad to set the time of day to 1:30. CLO will stay in the display.

3.Press start. CLO will disappear and the clock will start.

Setting 12 or 24 Hour Time of Day Display

1.Press and hold set clock for 6 seconds. CLO will appear in the display.

2.Continue holding the key until 12Hr dAY or 24Hr dAY appears in the display and the control beeps once.

3.Press self clean to switch between the 12 and 24 hour time of day display. The display will show either 12Hr dAY or 24Hr dAY.

4.Press start to accept the change or press off to reject the change.

5.Reset the correct time as described in this section. If the 24 hour time of day mode was chosen, the clock will display time from 0:00 through 23:59 hours.

24

Image 24

Frigidaire FGES3065PF manual Setting the Clock, Setting 12 or 24 Hour Time of Day Display, Oven Controls, Feature, Mode

Contents

TABLE OF CONTENTS Care and CleaningSetting Surface Controls WarrantyPRODUCT RECORD AND REGISTRATION Need Help?Product Registration Read this Use & Care ManualCAUTIONS AND WARNINGS IMPORTANT SAFETY INSTRUCTIONSTip Over Hazard IMPORTANT SAFETY INSTRUCTIONS IMPORTANT INSTRUCTIONS FOR USING YOUR COOKTOP IMPORTANT SAFETY INSTRUCTIONSIMPORTANT INSTRUCTIONS FOR USING YOUR OVEN IMPORTANT INSTRUCTIONS FOR CLEANING YOUR OVENSELF-CLEANING OVENS FOR GLASS COOKTOP ONLYFor models factory-equipped with a power cord For ovens to be wired into a junction boxGROUNDING INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSBEFORE SETTING SURFACE CONTROLS Using Proper CookwareCookware Material Types Figure 1 Testing cookwareElement ON & hot surface indicator lights BEFORE SETTING SURFACE CONTROLSFigure 3 Element ON indicator light locations About the Ceramic Glass CooktopThe electronic surface element control ESEC some models BEFORE SETTING SURFACE CONTROLSThe available ESEC display settings ESEC hot element indicator message HEBEFORE SETTING SURFACE CONTROLS ESEC error indicator message ErCooktop Sabbath Day Feature and Sb Message Home CanningSETTING SURFACE CONTROLS Surface cooking settingsTable 1 Recommended settings for surface elements SettingSingle radiant surface elements all models SETTING SURFACE CONTROLSFigure 8 Control knob shown is typical only To Operate the Single Radiant Surface ElementsDual Surface Radiant Element all models SETTING SURFACE CONTROLSTo Operate the Dual Surface Element Figure 9 Inner coil operation L and inner/outer coil operation RSETTING SURFACE CONTROLS Triple Surface Radiant Element some models SETTING SURFACE CONTROLSFigure 10 Single L, double M, and Triple R To Operate the Triple Surface ElementSETTING SURFACE CONTROLS Bridge surface radiant element some models SETTING SURFACE CONTROLSTo Operate the Bridge Radiant Element Keep warm zone some models SETTING SURFACE CONTROLSKeep warm zone temperature selection Table 2 Warm zone recommended food settingsBEFORE SETTING OVEN CONTROLS Oven vent locationType of oven racks Removing, replacing, and arranging flat or offset oven racksEffortless Oven Rack system BEFORE SETTING OVEN CONTROLSrack connector bracket door connector bracketBEFORE SETTING OVEN CONTROLS Figure 19 Effortless oven rack after assemblyEnd should point up, as explained in Step connector arm connectorOven Controls Features OVEN CONTROLSbake convect broilSetting the Clock Setting 12 or 24 Hour Time of Day DisplayTable 3 Minimum and maximum control settings FeatureSetting Continuous Bake or 6 Hour Energy Saving Temperature Display Fahrenheit/CelsiusSetting Control for Silent Operation Setting the TimerSetting Oven Lockout Feature Setting PreheatOven Light To activate the oven lockout featureSetting Bake To set the bake temperature to 375FTo change the bake temperature example changing from 375F to 425F OVEN CONTROLSSetting Broil Figure 23 Broil accessoriesOVEN CONTROLS To set a broil of 500FSetting Convection Bake Convection CookingTo set the oven for convection bake and temperature to 375F OVEN CONTROLSSetting Convection Convert Setting Convection BroilTo set a convection broil temperature of 500F OVEN CONTROLSSetting Convection Roast To set a convection roast temperature of 375FOVEN CONTROLS Convection roasting tipsSetting Bake Time Setting Delay Start8. Press delay start OVEN CONTROLSSetting Warm Setting My Favorites Recipe some modelsOVEN CONTROLS Warm tipsCooking with Meat Probe Figure 27 Using the probeProper placement of probe in food OVEN CONTROLSFigure 30 Probe set showing probe temperature Figure 32 Probe set to cancel cooking Probe too hot messageOVEN CONTROLS To set probeSetting Slow Cook some models Table 5 USDA recommended minimum internal cooking temperaturesOVEN CONTROLS Food TypeRestoring Factory Default Setting Adjusting Oven TemperatureTo adjust the oven temperature lower To restore oven control to factory default settingsSetting the Sabbath Feature For use on the Jewish Cooktop Sabbath Day Feature and Sb MessagePower failure while using Sabbath feature OVEN CONTROLSWarmer Drawer some models Figure 34 Downward position Warmer Drawer Indicator LightOVEN CONTROLS Warm & Ready DrawerSetting Warmer Drawer Professional Model Keep warm drawer temperature selectionTable 6 Warmer drawer recommended food settings SettingFigure 35 Removal procedures OVEN CONTROLSRemoving and Replacing the Warmer Drawer To remove the warmer drawer To replace keep warm drawerSteam Clean To set a steam clean cycleFigure 37 Steam clean selected 5. Press start Figure 38 Clean around the oven door gasketSelf-Cleaning Operation What to expect during self-cleaningAdhere to the following cleaning precautions Figure 39 Clean around the oven door gasketSetting Self-Clean Cycle Duration When the self-clean cycle is completedTo stop or Interrupt a self-cleaning cycle When the self-clean cycle is completedCARE AND CLEANING Cleaning Various Parts of Your RangeSurface Type RecommendationCARE AND CLEANING Control panelCooktop Maintenance Cooktop CleaningCARE AND CLEANING Figure 41 Cooktop cleaning Figure 40 Cooktop careCARE AND CLEANING General CleaningFigure 42 Cleaning products to avoid Do not use the following on the cooktopRemoving and Replacing the Oven Door CARE AND CLEANINGFigure 46 Replacement and location of hinge arm and roller pin To remove oven doorReplacing the oven light CARE AND CLEANINGReplacing the oven interior light bulb Figure 47 Wall oven Halogen lightBEFORE YOU CALL Oven BakingBaking Problems and Solutions Baking ProblemsSolutions to Common Problems ProblemSolution BEFORE YOU CALLsee “Cooktop Maintenance” on page information see “Cooktop Maintenance” on pageBEFORE YOU CALL nance” on pageCannot move appliance easily. Appliance must be accessible for service BEFORE YOU CALLWARRANTY