Frigidaire FGGF3032MB, FGGF3032MW, FGGF3032MF manual To assemble the Effortless Oven Rack system

Effortless™ Oven Rack system

Some models are equipped with a special oven rack system that automatically partially extends the oven rack from the interior oven glides to assist in easier access to your food items. This feature works whenever the oven door is opened or closed.

To assemble the Effortless™ Oven Rack system:

1.	Locate all required parts. You will need the supplied
	oven rack (Effortless™ Oven Rack is a flat rack with a
	special dark coating on the left and right rack
	sides) and the 2 supplied chrome connector arms.
2.	Open the oven door. Be sure the oven is completely
	cool before proceeding.
3.	Place the oven rack in positions 2, 3 or 4 only (see
	previous page to verify positions).Be sure the rack
	connector brackets are at the rear of the range and
	pointing towards oven bottom (See Fig. 2).
4.	Assemble one connector arm at a time. With the oven
	door open and the oven rack in place, install one end

BEFORE SETTING OVEN CONTROLS

IMPORTANT

•Only the Effortless™ Oven Rack system should be used in oven rack position 2. Placing ANY other rack in oven rack position 2 will prevent the oven door from fully closing and may damage the oven door, oven cavity or the door connector brackets.

•If the rack system is not assembled with the connector arms the Effortless™ Oven rack may be used in oven rack positions 2 thru 6. Do not attempt to use the Effortless™ Oven rack in rack position 1.

door	rack connector
connector	bracket
bracket

of the connector arm to the hole in the door

connector bracket (Fig. 1) and the other end in the

hole in the rack connector bracket (Fig. 2 and as in

Fig. 3). The oven rack may need to be adjusted in or

out in the rack position to match the length of the

connector arm.

5. While holding the connector arm in place, twist the

connector arm so the ends of the connector arm point

upwards (See Figs. 4 & 5). The connector arm

should now be locked into position.

6. Repeat steps 4 and 5 for the other connector arm.

Fig. 1

connector

arm

Fig. 3 - assembly of the Effortless™ Oven Rack

Fig. 2

oven

rack

7. Once both connector arms are properly in place, be

sure to test the oven rack operation by gently closing

the oven door. The oven rack should move in and out

of the oven freely when the door is opened or closed.

CAUTION

Never pick up hot oven rack parts. Make sure the oven and oven racks are COMPLETLY cool and safe to touch before attempting to assemble or disassemble the Effortless™ Oven Rack.

IMPORTANT

Remove ALL oven racks and accessories before starting a self-clean cycle. If the oven racks are left in the oven during self-clean, the glide ability of the Effortless™ Oven Rack system will be damaged and will cause oven racks to loose their shiny finish. Remove ALL oven racks and clean according to instructions provided in the Care & Cleaning section of this manual.

open oven	connector
door	arm

connector arm

Fig. 4

connector

arm

Fig. 5

left and right door connector

brackets

with connector arm ends shown in locked position (pointing upwards)

Fig. 6 - Effortless™ Oven Rack after assembly

9