1.2Accessing Equipment for Servicing
DANGER
Moving this equipment while it is filled with hot water may cause spilling or
splattering of the hot water. Always drain the cookpot before attempting to relocate
this equipment for servicing.
1.Disconnect the unit from the electrical power supply, the gas supply and the water supply.
2.Disconnect any attached restraining devices.
3.Relocate the unit for service accessibility.
4.After servicing is complete, reconnect the unit to the water supply and the gas supply. Reattach the restraining devices, and reconnect the unit to the electrical power supply.
1.3Replacing Equipment Components
1.3.1 Replacing the Controller
1.Open the control panel by removing the two screws on the bottom of the bezel. Disconnect the trouble light wires and lower the bezel. Remove the two screws in the upper edge of the control- ler and lower the controller and disconnect the
2.Remove the failed controller from the control panel and replace with the new controller. Re- verse steps to complete the process.
1.3.2 Replacing Electronic Components Other than the Controller
1.Drain the cookpot and disconnect the cooker form the electrical power supply.
2.The control box is mounted inside the bottom of the cabinet located beneath the cookpot.
3.On the component to be replaced, make a note of the wiring connection points. Disconnect the wires and remove the failed component. Install the replacement component and reconnect the wiring in accordance with the notes made, or with the wiring diagram on the door of the unit.
4.Replace the component box cover, and reinstall the controller being sure to reconnect the ground wire and trouble light wires. Reconnect the cooker to the electrical power supply.
