5.Remove the four bolts securing the motor mount to the frame, then remove the “motor and mount assembly” from the unit. NOTE: It is possible to replace a motor or the microswitch without removing the “motor and mount assembly”, but it is much more difficult.
6.Dismount the motor or microswitch as shown below and install the replacement.
NOTE: The right motor dismounts
in the same way as the left.
Loosen setscrew in bottom of cam (bell crank)
7. Reverse Steps 1-6 to complete the procedure.
1.3.7 Replacing Gas Supply System Components or Ignitor Assemblies
1.Disconnect the cooker from the electrical power supply and from the gas supply. If necessary, disconnect restraints to gain proper access to components.
2.Disconnect the component to be replaced (see illustration below) and install the replacement component. NOTE: If replacing the gas valve, disconnect the enrichment tubes and gas supply tubes at the valve, then unscrew the valve from the mounting bracket. Recover the fittings from the failed valve and install them on the replacement valve using a thread sealer suitable for gas appliances (Loctite™ PST 56765 is one example). Do not apply the sealer to the first two threads of the fitting. This will help prevent clogging of the burner orifices and gas valve.
