Remove the six screws in the faucet mounting plate.
Disconnect water line at this compression fitting.
Remove this nut to separate the faucet from the mounting plate.
Loosen this nut to separate the faucet from the water inlet manifold.
5.Separate the faucet from the water inlet manifold and mounting plate as shown in the illustration above.
6.Reverse Steps 1-5 to complete the procedure.
1.3.6 Replacing a Basket Lift Motor or Microswitch
1.Disconnect the cooker from the electrical power supply.
2.If rigid water connections have been used, disconnect the cooker from the incoming water supply.
3.Remove the basket lift arms from the lifter rods and then reposition the cooker to gain access to the rear. Remove the upper and lower basket lift rear panels.
4.Disconnect the basket lift synchronizer link from the lifter cam (bell crank) assemblies one at a time. When the link is disconnected from a cam, slip the corresponding lifter rod down and out of the assembly (see illustration on below).
Lifter Rods
Note the collection of washers and spacers between the link and lifter rods.
Synchronizer Link
Disconnect the basket lift synchronizer link from the lifter cams and slip the lifter rods down and out of the assembly.
Lifter Cams
