Chapter 3: Installation
3. Installation
This chapter gives
3.1 Selecting a Site for the Hardened Ethernet Extender Switch
As with any electric device, you should place the Hardened Ethernet Extender Switch where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:
•The ambient temperature should be between
•The relative humidity should be less than 95 percent,
•Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards.
•Make sure that the Hardened Ethernet Extender Switch receives adequate ventilation. Do not block the ventilation holes on each side of the Hardened Ethernet Extender Switch.
3.2 DIN Rail Mounting
•Connect the DIN rail attachment plate to the back panel of the Hardened
Ethernet Extender Switch.
•Installation: Place the Hardened Ethernet Extender Switch on the DIN rail from above using the slot. Push the front of the switch toward the mounting surface until you hear it snap into place.
•Removal: Pull out the lower edge and then remove the Hardened Ethernet
Extender Switch from the DIN rail.
Page 26 |
| LB308A |
|
|
