Chapter 6: Command Line Console Management
4. Example:
The following example specifies to add the interface fe1 (port 1) to VLANID (2): switch_a(config)#interface fe1
Port Based VLAN
Switchport portbase add/remove vlan:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use this command to set or remove the default VLAN for the interface.
3. Command Syntax:
switchport portbase add/remove vlan VLANID
VLANID The ID of the VLAN will be added to or removed from the
4. Example:
The following example specifies to add the interface fe1 (port 1) to VLANID (2): switch_a(config)#interface fe1
Page 164 |
| LB308A |
|
|
