Chapter 6: Command Line Console Management
switch_a(config)# IP Address
IP Address/IP Subnet Mask:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The
2.Usage: Use the ip address command to remove the IP address from an interface.
3.Command Syntax:
ip address IP-ADDRESS no ip address IP-ADDRESS no ip address
4.Example: The following example sets the new IP address 192.168.1.10 and new subnet mask 255.255.255.0 to Hardened Ethernet Extender Switch:
switch_a(config)#interface vlan1.1
Default Gateway:
1. Command Mode: Configure mode
Logon to ConfigureMode (Configure Terminal Mode) The switch _a(config)# prompt will show on the screen. switch_a(config)#
LB308A |
| Page 117 |
|
|