Chapter 6: Command Line Console Management
Port Security
Mode:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use this command to enable port security for port.
Use the no parameter with this command to disable port security for port.
3.Command Syntax:
4.Example:
The following example enables port security for interface fe1 (port 1): switch_a(config)#interface fe1
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
Page 132 |
| LB308A |
|
|
