Chapter 6: Command Line Console Management
6.2 System
System Information, System Name/Password, IP Address, ARP Table, Route Table, Save Configuration, Firmware Upgrade, Alarm Setting, Reboot, Logout
System Name/Password
System Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.Usage: Use the hostname command to set or change the network server name. Use the no hostname command to disable this function.
3.Command Syntax: (no) hostname HOSTNAME HOSTNAME specifies the network name of the system
4.Example: The following example sets the hostname to Hardened Ethernet Extender Switch, and shows the change in the prompt:
switch_a(config)#hostname switch
switch(config)#
Password:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode)
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.Usage: Use enable password command to modify or create a password to be used when entering the Enable mode.
3.Command Syntax: enable password PASSWORD
PASSWORD specifies the new password of the system.
4.Example: The following example sets the new password my passwd to the Hardened Ethernet Extender Switch:
switch_a(config)#enablepasword mypasswd
Page 116 |
| LB308A |
|
|
