Black Box 8-port 10/100base-tx hardened ethernet extender switch Command Line Console Management

Chapter 6: Command Line Console Management

4. Example:

The following example shows setting storm-control dlf enable to the interface fe1 (port 1):

switch_a(config)#interface fe1

switch_a(config-if)#storm-control dlf enable

switch_a(config-if)#

Static MAC Entry

Static-MAC-Entry Forward:

5. Command Mode: Configure mode

Log on to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen.

switch_a(config)#

6. Usage:

Use this command to statically configure a bridge entry to forward matching frames.

7. Command Syntax:

bridge GROUP address MAC forward IFNAME VLANID

no bridge GROUP address MAC forward IFNAME VLANID

GROUP <1-1> Bridge-group ID used for bridging.

MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH format.

IFNAME the interface on which the frame comes in.

VLANID The VID of the VLAN that will be enabled or disabled on the bridge <2-4094>.

8. Example:

The following example configures a bridge GROUP (1) to forward matching frames (MAC address 2222.2222.2222) to the interface fe1 (port 1) in vlan VLANID (2):

switch_a(config)#bridge 1 address 2222.2222.2222 forward fe1 vlan 2

switch_a(config)#

LB308A 724-746-5500 blackbox.com Page 137