Chapter 6: Command Line Console Management
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen. switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control broadcast enable command to enable broadcast traffic. Use no storm-control broadcast command to disable broadcast traffic.
3. Command Syntax: storm-control broadcast enable no storm-control broadcast
4. Example:
The following example shows setting storm-control broadcast enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control broadcast enable switch_a(config-if)#
Multicast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen. switch_a(config)#interface fe1
switch_a(config-if)#
LB308A | 724-746-5500 blackbox.com | Page 135 |
| |
