Black Box LB308A user manual Command Syntax vlan database

Chapter 6: Command Line Console Management

2. Usage:

Use vlan database command to enter the VLAN configuration mode.

3.Command Syntax: vlan database

4.Example:

The following example changes to VLAN configuration mode from Configure mode:

switch_a(config)#vlan database

switch_a(config-vlan)#

Add VLAN/Delete VLAN:

1. Command Mode: VLAN Configure mode

Logon to Configure Mode (Configure Terminal Mode). Logon to VLAN Configure Mode. The switch_a(config-vlan)# prompt will show on the screen.

switch_a(config)#vlan database

switch_a(config-vlan)#

2. Usage:

This command enables or disables the state of a particular VLAN on a bridge basis. Specifying the disable state causes all forwarding over the specified VLAN ID on the specified bridge to cease. Specifying the enable state allows forwarding of frames on the specified VLAN-aware bridge.

3. Command Syntax:

vlan VLANID bridge GROUP name VLAN_NAME state enable/disable

no vlan VLANID bridge GROUP

VLANID The VID of the VLAN that will be enabled or disabled on the bridge <2-4094>.

GROUP <1-1> The ID of the bridge-group on which the VLAN will be affected.

VLAN_NAME The ASCII name of the VLAN. Maximum length: 16 characters.

enable Sets VLAN into an enable state.

disable Sets VLAN into a disable state.

Page 158 724-746-5500 blackbox.com LB308A