Chapter 6: Command Line Console Management
2. Usage:
Use storm-control multicast enable command to enable multicast traffic. Use no storm-control multicast command to disable multicast traffic.
3. Command Syntax: storm-control multicast enable no storm-control multicast
4. Example:
The following example shows setting storm-control multicast enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control multicast enable switch_a(config-if)#
DLF:
1. Command Mode: Interface mode
Log on to Configure Mode (Configure Terminal Mode). Then log on to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen. switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control dlf enable command to enable destination lookup failure traffic. Use no storm-control dlf command to disable destination lookup failure traffic.
3.Command Syntax: storm-control dlf enable no storm-control dlf
dlf destination lookup failure
Page 136 | 724-746-5500 blackbox.com | LB308A |
| |
