Chapter 6: Command Line Console Management
2. Usage:
Use this command to set the interval when the configuration would be automati- cally saved. The range of interval value is from 5 to 65535. The default value is 30 seconds.
3. Command Syntax:
service
WORD specifies the interval value.
4. Example:
The following example sets the interval WORD (10) when the configuration would be automatically saved to Hardened Ethernet Extender Switch:
switch_a(config)#service
switch_a(config)#
Firmware Upgrade
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode). The switch_a# prompt will show on the screen.
switch_a#
Usage:
Use install image command to upgrade firmware from tftp server to Hardened Ethernet Extender Switch.
3. Command Syntax:
install image
WORD specifies the file name to be upgraded to Hardened Ethernet Extender Switch.
4. Example:
The following example specifies upgrading firmware (file name: flash.tgz) from
tftp server (IP address: 192.168.1.100) to Hardened Ethernet Extender Switch:
switch_a#install image 192.168.1.100 flash.tgz
switch_a#
LB308A |
| Page 123 |
|
|
