Chapter 6: Command Line Console Management
2. Usage:
Use set gvrp enable bridge command to enable (set) and set gvrp disable bridge command to disable (reset) GVRP globally for the bridge instance. This command does not enable/disable GVRP in all ports of the bridge. After enabling GVRP globally, use the set port gvrp enable command to enable GVRP on individual ports of the bridge.
3. Command Syntax:
set gvrp enable bridge GROUP
set gvrp disable bridge GROUP
GROUP
4. Example:
The following example globally enables GVRP to bridge GROUP (1):
switch_a(config)#set gvrp enable bridge 1
switch_a(config)#
Dynamic VLAN creation:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use set gvrp
3. Command Syntax:
set gvrp
set gvrp
GROUP
LB308A |
| Page 189 |
|
|
