Black Box LB308A user manual Command Line Console Management

Chapter 6: Command Line Console Management

1. Command Mode: Interface mode

Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.

fe1 means port 1.

The switch_a(config-if)# prompt will show on the screen.

switch_a(config)#interface fe1

switch_a(config-if)#

2. Usage:

Use switchport mode hybrid command to set the switching characteristics of the Layer-2 interface as hybrid, and classify both tagged and untagged frames.

Use the no switchport hybrid command to reset the mode of the Layer-2 interface to access (default).

3.Command Syntax: switchport mode hybrid

switchport mode hybrid acceptable-frame-type all/vlan-tagged no switchport hybrid

all Set all frames can be received.

vlan-tagged Set vlan-tagged frames can only be received.

4.Example:

The following example sets the switchport mode hybrid of the interface fe1 (port

1)and all frames to be received on interface fe1 (port 1): switch_a(config)#interface fe1 switch_a(config-if)#switchport mode hybrid acceptable-frame-type all switch_a(config-if)#

Switchport mode trunk:

1. Command Mode: Interface mode

Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.

fe1 means port 1.

Page 160 724-746-5500 blackbox.com LB308A