Chapter 6: Command Line Console Management

switch_a(config)#interface fe1 switch_a(config-if)#

2. Usage:

Use spanning-tree link-type command to set the link type of a port to enable or disable rapid transition.

Use the no spanning-tree link-type command to set a port to its default state and to disable rapid transition.

3. Command Syntax:

(no) spanning-tree link-type LINKTYPE

LINKTYPE The link type to be assigned to the port. point-to-point Enable rapid transition.

shared Disable rapid transition.

4. Example:

The following example sets the link-type LINKTYPE (point-to-point) of the interface fe1 (port 1):

switch_a(config)#interface fe1

switch_a(config-if)#spanning-tree link-type point-to-point switch_a(config-if)#

Autoedge:

1. Command Mode: Interface mode

Logon to Configure Mode (Configure Terminal Mode).

Then logon to Interface mode.

fe1 means port 1.

The switch_a(config-if)# prompt will show on the screen. switch_a(config)#interface fe1

switch_a(config-if)#

2. Usage:

Use spanning-tree autoedge command to assist in automatic identification of the edge port.

Page 148

724-746-5500 blackbox.com

LB308A

 

 

Page 148
Image 148
Black Box LB308A, 8-port 10/100base-tx hardened ethernet extender switch user manual Command Line Console Management