Chapter 6: Command Line Console Management
The
switch_a(config)#interface fe1
2. Usage:
Use switchport mode trunk command to set the switching characteristics of the
Use the no switchport trunk command to reset the mode of the
3.Command Syntax: switchport mode trunk no switchport trunk
4.Example:
The following example sets the switchport mode trunk of the interface fe1 (port 1):
switch_a(config)#interface fe1
Switchport hybrid allowed vlan:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config)#interface fe1
2. Usage:
Use this command to set the switching characteristics of the
Use the no parameter to turn off allowed hybrid switching.
LB308A |
| Page 161 |
|
|
