Chapter 6: Command Line Console Management
Duplex:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use duplex command to specify the duplex mode to be used for each interface. Use the no duplex to disable this function.
3.Command Syntax: (no) duplex MODE
MODE specifies the duplex mode: auto, full, half.
4.Example:
The following example shows the use of duplex MODE (full) to the interface fe1 (port 1):
switch_a(config)#interface fe1
Flow control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface mode.
fe1 means port 1.
The
Page 128 |
| LB308A |
|
|
