Black Box 8-port 10/100base-tx hardened ethernet extender switch Command Line Console Management

Chapter 6: Command Line Console Management

4. Example:

The following example enables NTP for the Hardened Ethernet Extender Switch: switch_a(config)#ntp enable

switch_a(config)# NTP Server:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#

2. Usage:

Use this command to specify the IP address or Domain name of NTP server.

3. Command Syntax:

ntp server IP-ADDRESS｜DOMAIN-NAME

IP-ADDRESS A.B.C.D specifies the IP address of NTP server.

DOMAIN-NAME Specifies the Domain name of NTP server.

4. Example:

The following example specifies the IP address (192.168.1.100) of NTP server: switch_a(config)#ntp server 192.168.1.100

switch_a(config)# Sync Time:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#

2. Usage:

Use ntp sync-time command to synchronize time with NTP server.

LB308A 724-746-5500 blackbox.com Page 199