PRINTER CONFIGURATION

5

DIP SWITCH PANELS

There are two DIP switches (DSW2 and DSW3) located on the front panel under a protective cover. A third DIP switch is located on the RS232C Serial Adapter card and is used to set the RS232C transmit/receive parameters.Each switch is an eight section on/off toggle type switch. The ON position is always oriented upward and consequently, the off is always downward. Switch settings are read by the printer electronics during the power up sequence and will not become effective until the power is cycled.

RS232 TRANSMIT/RECEIVE SETTING

Data Bit Selection (DSW1-1):Sets the printer to receive either 7 or 8 data bits for each byte transmitted.

DSW1-1

SETTING

 

 

Off

8 Data Bits

 

 

On

7 Data Bits

 

 

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Parity Selection (DSW1-2,DSW1-3):Selects the type of parity used for error detection.

DSW1-1

DSW1-3

SETTING

DSW1

 

 

 

ON

 

 

 

 

 

 

 

 

Off

Off

No Parity

 

 

 

 

 

 

 

 

 

 

 

OFF

 

 

 

 

 

 

 

 

Off

On

Even

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On

Off

Odd

 

1 2 3 4 5 6 7 8

 

 

 

 

 

 

 

 

 

 

 

 

On

On

Not Used

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SATO M10e Service Manual

PN: 9001113A

Page 5-1

Page 31
Image 31
SATO 10e service manual DIP Switch Panels, RS232 TRANSMIT/RECEIVE Setting, Off