SATO 10e service manual Setting DSW3, DSW3 OFF

Section 5: Printer Configuration

Status Select(DSW2-8):For emulating earlier series software commands. Should be used only if problems are encountered when using existing software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.

DSW2-8	SETTING
Off	Status 3 & 4 Enabled
On	Status 2 & 3 Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Backfeed Sequence (DSW3-1,DSW3-2):Backfeed is used to correctly position the label for application and then retract the next label to the proper print position. This operation can be performed immediately after a label is printed and used, or immediately prior to the printing of the next label.

DSW3-1		SETTING	DSW3
			ON
Off	Off	Continuous
Off	On	Tear-Off	OFF
On	Off	Cutter*		1 2 3 4 5 6 7 8
On	On	Not Used

* Defaults to Continuous if cutter not installed

Label Sensor Selection (DSW3-3):Enables or disables the Label Sensor. If the Sensor is enabled, it will detect the edge of the label and position it automatically. If it is disabled, the positioning must be under software control using Line Feed commands.

DSW3-3	SETTING
Off	Not Used
On	Sensor Used

DSW3

ON

OFF

1 2 3 4 5 6 7 8

SATO M10e Service Manual PN 9001113A Page 5-5