Section 8: Adjustment Procedures

4Turn dial (5) on test module (3) to position number 0.

5Connect the positive (+) probe of the multimeter to connection port (6) on test module (3).

6Connect the negative (-) probe of the multimeter to pin GRD (7) on test module (3).

7Ensure the multimeter is for DC voltage reading.

8Place a label without the eye-mark part in position to be read by the sensor.

9Adjust VR8 potentiometer (2) so that the multimeter value is less than 1.0 volts.

10Replace the label without the eye-mark with one that has the eye-mark for sensor reading.

11Observe the multimeter for a value of +3.0 volts more than the prior value read.

12Repeat steps 8 through 11 until the value is 3.0 volts.

13Test print labels to ensure proper function.

14Disconnect test module (3) from main circuit board (1).

15Disconnect test module (3) from main circuit board (1) and replace housing covers.

NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance on housing cover installation.

OFFSET LABEL STOP POSITION ADJUSTMENT

The following procedure provides for fine adjustment of the label stop position for Tear-Off and Cutter Modes. The feed/backfeed is adjusted with the OFFSET potentiometer located on the upper surface of the left housing cover. The Offset adjustment range is +/- 3.75mm.

NOTE: Figure 10-4 Block Diagram; Figure 10-5, Accessories & Sensors

Location; and Figure 10-6, Print Reference Position of the Diagram &

Schematics section provides additional guidance.

NOTE: Only the stop position is changed with the Offset potentiometer. The print position is changed using the Pitch potentiometer.

1 Turn the OFFSET (VR2) potentiometer dial midway of the scale.

NOTE: The Offset potentiometer is located on the upper surface of the left housing cover.

2Press and hold the FEED key while switching on the printer.

3Release the FEED key when the printer emits an audible beep.

 

 

 

 

 

LCD DISPLAY:

TEST PRINT MODE

 

 

 

CONFIGURATION

 

 

 

 

 

4 Press the ENTER key to advance to the next display.

SATO M10e Service Manual

PN: 9001113A

Page 8-16

Page 112
Image 112
SATO 10e service manual Offset Label Stop Position Adjustment