Section 5: Printer Configuration
CLEAR NON-STANDARD PROTOCOL
The standard protocol codes used by the printer can be modified to accomodate the requirements of different host systems. However, if the printer is to be used with a system that does not use the custom protocol codes, they can be cleared and the default protocol codes reactivated. The default values are: STX = 7BH, ETX = 7DH, ESC = 5EH, ENQ = 40H, NULL = 7EH, CAN = 21H and OFFLINE = 5DH.
LCD DISPLAY |
| DEFINITION |
|
| |
V 05.00.03.00 | Displays the firmware during the initialization. | |
INITIALIZING |
|
|
ALT.PROTOCOL | To Clear | |
DEFAULT COMPLETE | 1. | Place |
| ||
| 2. | Press and hold the LINE and FEED keys while switching on the printer. |
| 3. | Release the LINE and FEED keys when the printer emits one long beep. |
| 4. | Standby for the printer to replace the Alternate protocol codes with the |
|
| default values. |
| The printer will emit two short beeps when the process is complete. To exit the | |
| mode, power the printer off and then back on. | |
|
|
|
DOWNLOAD USER DEFINED PROTOCOL CODES
The user can define a set of custom protocol codes and download them to the printer using the <ESC>LD command.
LCD DISPLAY |
| DEFINITION |
|
| |
V 05.00.03.00 | Displays the firmware during the initialization. | |
INITIALIZING |
|
|
USER DOWNLOAD | Allows the replacement of the Standard Protocol Codes or the Alternate set of | |
PRESS THE LINE KEY | Protocol Codes. To enter the User Download mode: | |
| 1. | Place |
| 2. | Press and hold the LINE and FEED keys while switching on the power. |
| 3. | Release the LINE and FEED keys when the printer emits one long beep. |
|
|
|
USER DOWNLOAD | 4. | Press the LINE key. The printer is now waiting for the data to be sent. |
WAITING | 5. | Transmit the download data command stream to the printer. |
| ||
| After the data has been received, the printer will beep and print a status label. | |
| If it does not beep and print a status label, the printer did not accept the data. | |
| If the printer did not beep and print a status label, turn the printer off and check | |
| your data stream for errors and start the download process over. | |
| If the custom codes are correct, press the ENTER key to select and terminate | |
| the download process. If they are incorrect, turn the printer off without | |
| pressing the ENTER key and begin the process again. | |
SATO M10e Service Manual | PN 9001113A | Page |
