SATO 10e service manual Auto Load Sensor Adjustment, 9, Label Gap Sensor Adjustment

Section 8: Adjustment Procedures

		0	1
	8
7			2

5	6	3
	5	4
		D SIG
3	GN

2

7 6

1

1A 2A 3A 4A 5A 6A 1B 2B 3B 4B 5B 6B

84+ RS	BOARD
IEEE12

4

		1A
		2A
		3A
0		4A
	1	5A
8
		6A
7	2	1B
		2B
6	3	3B
5	4	4B
GND	SIG	5B
		6B
3

Figure 8-9, Label Gap Sensor Adjustment

AUTO LOAD SENSOR ADJUSTMENT

This adjustment will require the use of a multimeter and the TP Test Module.

NOTE: Figure 10-4, Block Diagram, Figure 10-5, Accessories & Sensors Location; and Figure 10-6, Print Position Reference Diagram of the Diagrams & Schematics section provide additional instruction.

1 Remove the top, front, and left housing cover to access main circuit board (1, Figure 8-10).

NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance on housing cover removal.

2 Turn VR7 potentiometer (2) fully counter-clockwise.

NOTE: An audible click should be heard.

3 Connect test module (3) to main circuit board connector (4).

SATO M10e Service Manual PN 9001113A Page 8-13