![](/images/new-backgrounds/1185794/18579473x1.webp)
Section 5: Printer Configuration
Repeat Print via External Signal
SETTING | |
|
|
Off | Enabled |
|
|
On | Disabled |
|
|
DSW3
ON
OFF
1 2 3 4 5 6 7 8
DEFAULT SETTINGS
All switches are placed in the Off default position for shipping. This will result in the following operating configuration:
| DEFAULT SETTINGS |
|
|
Communications: | 8 data bits, no parity, 1 Stop bit, 9600 Baud |
Protocol: | Ready/Busy |
Sensor: | Gap Sensor |
Receive Buffer: | Multi Job |
Mode: | Batch/continuous |
Label Sensor: | Sensor Used |
Backfeed: | Enabled |
External Signals: | Enabled |
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again changed by receipt of a command containing a new setting. These settings are stored in
| SOFTWARE DEFAULT SETTINGS | |
|
|
|
Print Darkness |
| 3 |
Print Speed |
| 4 Inches Per Second |
Print Reference |
| Vertical = 0000, Horizontal = 0000 |
Zero |
| Slash |
Auto On Line |
| Enabled |
Feed on Error |
| Enabled |
Feed Reprint |
| Disabled |
Priority |
| Command |
SATO M10e Service Manual | PN 9001113A | Page |