Section 8: Adjustment Procedures

ROLLER BELT ADJUSTMENT

1Switch off power and disconnect power supply cord.

2Remove the top, front, and right housing covers to gain access to roller belt (1, Figure 8-4).

NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance on housing cover removal.

3Loosen two screws (2) and manipulate tension roller bracket (3) upward to apply tension to belt (1).

NOTE: Belt tension should be slightly snug but not tight. Excessive belt tension will reduce belt life.

4Retighten two screws (2) to secure tension roller bracket (3) and belt (1).

5Install the right, front, and top housing covers.

NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance on housing cover installation.

1

2

2

3

Figure 8-4, Roller Belt Adjustment

SATO M10e Service Manual

PN 9001113A

Page 8-5

Page 101
Image 101
SATO 10e service manual Roller Belt Adjustment