Frymaster H14, H17, H22 manual 29

INTERNATIONAL KESSEL SERVICE

Problem	Probable Causes	Corrective Action
		This display is normal when the
		fryer is first turned on and may
		appear for a short while if a large
		batch of frozen product is added to
		the frypot. If the display never
		goes out, the fryer is not heating.
		Look for a decimal in the LED
		display between digits 1 and 2. If
		the decimal is present, the
CM III		computer is calling for heat and is
		functioning properly. See Fryer
or	Frypot temperature is more than 21ºF
Digital Controller	(12ºC) below setpoint.	Does Not Heat in Control and
		Heating Problems (Section 6.2.1).
display shows .
		If the decimal is not present, the
		computer is not calling for heat and
		may be malfunctioning. If
		available, substitute a controller
		known to be working for the
		suspect computer. If the fryer
		functions correctly with the
		substitute computer, order a
		replacement computer from your
		FASC.
CM III		This indicates a problem within the
or	Problem with the temperature	temperature measuring circuitry
Digital Controller	measuring circuitry including the	that is beyond the scope of
display shows	probe.	operator troubleshooting. Shut the
.		fryer down and call FASC.
		The CM III computer may be
		programmed for constant
CM III frypot		temperature display or countdown
	Computer is programmed for	timer display. Refer to the separate
temperature is
	constant temperature display.	Frymaster Fryer Controllers
displayed constantly.
		User's Manual for instructions on
		toggling between these display
		options.
		This in an indication of a
		malfunction in the temperature
		measuring or control circuitry,
Solid state controller	Oil temperature above acceptable	including a failure of the high-limit
	range or a problem with the	thermostat. Determining the
trouble light ON.
	temperature measuring circuitry.	specific problem is beyond the
		scope of operator troubleshooting.
		Shut the fryer down immediately
		and call FASC.

WWW.INTERNATIONALKESSEL6-6.COM