How to use the SET UP menu (➝p.138)

2 Enter a comment.

INPUT COMMENT

1234567890_ABCDEFGHIJKLMNOP QRSTUVWXYZ!"#$%&'()*+,->/:;< =>?@[]{}

DONE DELETEINSERT

ARotate the main-command dial to display the desired first letter to enter.BPress qto enter the second letter.

MEMO

•Repeat the steps A-Bto enter more letters.•Press por qto select the letter to delete, then press nto delete.•To insert a letter between other letters, press por qto select the letter after the inserting position, then press oto insert.3 Exit from [IMAGE COMMENT].

Press MENU/OK.

BARCODE READER/GPS

Store information from a barcode reader or GPS connected to a 10-pin terminal as Exif information.

[BCR 1 SHOT]

Read barcode information for each shot and store it as comment information. Pictures cannot be taken without reading a new barcode.

[BCR CONTINUOUS]

Store registered barcode information as comment information in every file. To erase the registered information, read the “barcode eraser” on this page or delete the letters registered in the [IMAGE COMMENT].

[GPS]

Store information from GPS device allowing latitude, longitude, altitude and UTC (standard universal coordinated time) to be recorded with photographs.

[OFF]

No store barcord or GPS information is retrieved.

MEMO

•When the barcode information is stored, BCD is displayed in the control panel.•The following ASCII characters can be used for the barcode information:

(space), 0~9, _(under bar), A~Z (lower-case characters can be entered using barcode reader, however they cannot be reviewed or edited on the [INPUT COMMENT] screen.), ! ” # $ % & ’ ( ) * + - . / : ; < = > ?

@ [ ] { }.

Usable types of barcode depend on the specifications of the barcode reader.

Continued Q

Settings

147