FujiFilm FinePix S5 Pro USET UP, CAUTION, •EOF: CR+LF, ZBarcode eraser, •Parity check: –, •Stop bit: 1 bit, ZUsing a GPS Unit, •Data length: 8 bit, •Baud rate: 4800 bps

USET UP How to use the SET UP menu (➝p.138)

•When the [BCR 1 SHOT] or [BCR CONTINUOUS] is set, the maximum number of characters or storing mode (overwrite or add) varies depending on the [IMAGE COMMENT] setting.

ZConnecting to barcode reader

You can use the barcode reader with a D-sub 9-pin connector (commercially available).Connect the barcode reader to the camera using MC-35. See the barcode reader instruction manual for details.

Barcode reader setting•Baud rate: 4800 bps•Data length: 8 bit•Parity check: –•Stop bit: 1 bit•EOF: CR+LFZBarcode eraser

Use the barcode reader to read the barcode below to erase the last barcode information.

148

ZUsing a GPS UnitGarmin and Magellan GPS units that conform to version

2.01of the National Marine Electronics Association NMEA0183 data format can be connected to the camera’s ten-pin remote terminal using an MC-35 GPS adapter cord (available separately), allowing information on the camera’s current position to be recorded when photographs are taken. Operation has been confirmed with the following devices:

• Garmin eTrex series equipped with a PC interface cable connector• Magellan SporTrak series equipped with a PC interface cable connector

These devices connect to the MC-35 using a cable with a D-sub 9-pin connector provided by the manufacturer of the GPS device. See the MC-35 instruction manual for details. Before turning the camera on, set the GPS device to NMEA mode (4800 baud).

CAUTION

•When attaching the GPS device, be sure to turn the GPS device OFF.

•When attaching the GPS device, if [BARCODE READER/GPS] is set to [BCR 1 SHOT] or [BCR CONTINUOUS], the GPS device cannot be connected. Briefly turn the camera off and set to [GPS].