Fujitsu C1410 Memory Problems, module. See Memory Upgrade Module on page, for more information

clio.book Page 52 Friday, June 2, 2006 10:37 AM

L i f e B o o k C 1 4 0 0 S e r i e s N o t e b o o k - S e c t i o n F i v e

Problem	Possible Cause		Possible Solutions
Memory Problems
Your Power On screen, or	Your memory upgrade module	Remove and re-install your memory upgrade
Main menu of the BIOS	is not properly installed.	module. (See Memory Upgrade Module on page 42
setup utility information,		for more information)
does not show the correct
	You have a memory failure.	Check for Power On Self Test (POST) messages.
amount of installed
		(See Power On Self Test Messages on page 57 for more
memory.
		information)
Modem Problems
Messages about modem	Modem operation messages	See your application software documentation for
operation.	are generated by whichever	additional information.
	modem application is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel	The device is not properly	Remove and re-install the device. (See Device Ports
port device, a serial port	installed.	on page 44 for more information)
device or a USB device.
	The device may have been	Close the application and restart your notebook.
Your LifeBook notebook
	installed while an application
does not recognize the
	was running, so your notebook
device, or the device does
	is not aware of its installation.
not seem to work properly.
	Your device may not have the	See your software documentation and activate the
	correct software driver active.	correct driver.
	You may have the wrong I/O	See your device documentation and software docu-
	address selected for the device.	mentation to determine the required I/O address.
		Change the settings in the BIOS setup utility. (See
		BIOS Setup Utility on page 27 for more information)
	Your device and another device	Check all I/O addresses located within the BIOS
	are assigned the same I/O	setup utility and any other installed hardware or
	address.	software to make sure there are no duplications.
	Parallel port is set to output	Check parallel port setting in the BIOS and set to
	only.	bi-directional or ECP.
PC Card Problems
A card inserted in the PC	The card is not properly	Remove and re-insert the card. (See PC Cards/
Card slot does not work or	inserted.	ExpressCards™ on page 40 for more information)
is locking up the system.
	The card may have been	Close the application and restart your notebook.
	inserted while an application
	was running, so your notebook
	is not aware of its insertion.
	Your software may not have	See your software documentation and activate the
	the correct software driver	correct driver.
	active.
	You may have the wrong I/O	See your PC Card documentation to determine
	address selected for your PC	the required I/O address. Change the settings in
	Card device.	the BIOS. (See BIOS Setup Utility on page 27 for
		more information)
	Your PC Card device and	Check all I/O addresses located within the BIOS
	another device are assigned the	setup utility and any other installed hardware or
	same I/O address.	software to make sure there are no duplications.
52