Fujitsu C1410 manual Deactivating The Wlan Device, Activating The Wlan Device

(See Installing Click Me! on

clio.book Page 87 Friday, June 2, 2006 10:37 AM

■The WLAN device operates in the 2.4 GHz ISM band and the 5 GHz lower, middle, and upper UNII bands.

■Microwave ovens may interfere with the operation of WLAN devices since they operate in the same 2.4 GHz frequency range as IEEE802.11b/g devices. Interfer- ence by microwaves does not occur with IEEE802.11a radio which operates in the 5 GHz RF band.

■Wireless devices that transmit in the 2.4 GHz fre- quency range may interfere with the operation of WLAN devices in IEEE802.11b/g modes. Symptoms of interference include reduced throughput, intermittent disconnects, and large amounts of frame errors. It is recommended that these interfering devices be pow- ered off to ensure the proper operation of the WLAN.

DEACTIVATING THE WLAN DEVICE

Deactivation of the WLAN device may be desired in certain circumstances (to extend battery life) or where certain environments require it (i.e. hospitals, clinics, airplanes, etc.). Fujitsu mobile computers employ two methods with which to deactivate the WLAN device,

1)the Wireless On/Off Switch, and, 2) in Windows using the Intel PROSet for Wireless utility.

Before using the wireless LAN device, you must first install ClickMe! to ensure that the correct software for your device is installed.

page 28 for more information)

Figure A-2. Access Point (Infrastructure) Mode Network

ADSL modem,

Internetcable modem, or similar

Wireless LAN

W i r e l e s s L A N U s e r ’ s G u i d e

Deactivation using the Wireless On/Off Switch

The WLAN device can be deactivated quickly and effi- ciently by toggling the Wireless On/Off Switch to the Off position. The switch is located on the left side of the system. (Figure A-3)

The switch has no effect on non-Wireless LAN models.

WLAN Switch

Figure A-3. Wireless LAN On/Off Switch

Deactivation using Intel PROSet for Wireless Utility

The WLAN device can also be deactivated in Windows using the Intel PROSet for Wireless utility. The proce- dure to accomplish this:

1.Click [Start]-> [All Programs].

2.Select Intel ProSet Wireless, then click on Intel ProSet Wireless from the menu that appears. The Intel ProSet Wireless utility will be displayed.

3.At the bottom left corner of the window, select Wireless Off from the dropdown list.

ACTIVATING THE WLAN DEVICE

Activation of the WLAN device can be accomplished using the same methods as the deactivation process.

■Using the Wireless On/Off Switch

■In Windows using Intel PROSet for Wireless

Wired LAN

Access Point*

*An optional hub for a wired LAN may be required depending upon the type of access point used.

87