Fujitsu DL7400 EXIT SAVING AND , ING

USING SETUP MODE
To
An
on defaults for the printer. The new defaults remain active until you
cha
us
ON>> menu.
> menu should be the last printed line on
s not printed, press the ONLINE button to
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE
HEX-DUMP V-ALMNT INITIAL
exit setup mode immediately, select the SAVE & END function.
y settings changed while in setup mode are saved as the new power-
nge them again.
NOTE
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the previo
default settings are used.
Procedure
To exit setup mode and save your changes using SAVE/END, proceed as
follows:
1. Print the <<FUNCTI
The <<FUNCTION>
the page. If the menu i
print the menu. The <<FUNCTION>> menu is shown below:
ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-TST
2. Select the SAVE/END function.
m print
s positioned under SAVE & END. Press the S button or
EXIT
SAVING AND ING
Make sure that the cursor on the left edge of the aluminu
guide i
the T button to select SAVE & END. The printer exits setup
mode and returns online (the ONLINE indicator lights green).
Any changes you made while in setup mode are saved.
5-50 User's Manual