2.2 Connecting ScanSnap to your Computer
■Connecting the USB Cable
Connect the USB cable as shown below.
ATTENTION
• Use only the USB cable supplied with the scanner. Operation with a commercially available USB cable is not guaranteed.
•When connecting to a USB hub, be sure to connect the scanner to the hub nearest to your computer (first stage). If you connect to a USB hub from the second stage onwards, ScanSnap may not function correctly.
•If you connect the scanner using USB 2.0, please make a sure that both the USB port and the Hub are compliant with USB 2.0. The scanning speed may slow down when you connect the scanner using USB 1.1. If your computer has USB 2.0 port, please use it.
1.Remove the seal on the rear side of the ScanSnap scanner.
USB connector
Seal
2.Insert the USB cable into the USB connector of ScanSnap and plug the other end of the cable into the USB port of your computer.
Insert the USB cable firmly as far as it can go into the connector.
USB cable
2
ScanSnap Connecting
ScanSnap |
| 17 |
|