Fujitsu fi-5110EOXM while pulling the shaft to the left, 5.Remove the Pick roller with its shaft, 6.Remove the Pick roller from the shaft

5.Remove the Pick roller with its shaft.

Hold the left part of the shaft, and raise it to remove the shaft from the scanner while pulling the shaft to the left.

8.Install the Pick roller with its shaft into the scanner. and set the shaft to the slot while lowering it.

Shaft

Bushing

Pick roller

Pick roller shaft	Pick roller
ATTENTION	If the around the pick roller is dirty by paper
	-powder, it may cause a scanning error.
	Please remove the dirt using a dry cloth with
	dollop of Cleaner F1.

*Don't use water, mild detergent or air-spray.

6.Remove the Pick roller from the shaft.Pull out the shaft from the Pick roller while lifting up its tab.

Tab

	Shaft
	Pick roller
ATTENTION	it may crack or chip your fingernail.
	If you worry about that, push up the pick roller
	tab using a paper clip.
	1

2

7.Attach the new Pick roller to the shaft.

Insert the new Pick roller aligning the protrusion with the slot on the Pick roller.

Pick roller

Groove

ShaftProtrusion

9.Fix the Pick roller bushing (left) by rotating it in the direction of the arrow.

	Pick roller bushing
Pick roller	Shaft
ATTENTION	Make sure that the Pick roller is
	completely attached and correctly
	installed. Otherwise, document jams or
	other feeding errors may occur.

10.Attach the sheet guide to the scanner.

While holding the handle on the sheet guide, set the sheet guide into the scanner.

Sheet guide Handle

Craw

ÖYou should hear the sheet guide click when it returns to its original position.

ScanSnap fi-5110EOXM for Macintosh Getting Started 17