1. Preparation
This chapter describes necessary preparations before using ScanSnap.ATTENTIONDo not connect the scanner to your PC
before installing “ScanSnap Manager”.
If the scanner is connected before installing ScanSnap Manager, it will not operate correctly.
Refer to Chapter 2 for the installation of ScanSnap Manager.
1.1.Checking the Contents of the Package
When you unpack the scanner package, make sure that all parts are included.Refer to the package contents list included the scanner package box.1.2. Names and Functions of Parts
This section describes the names and functions of parts.Front Side
Paper chute cover Open this cover when using the scanner.
→Opening the cover turns
ON the scanner.
ADF cover
(ADF: Automatic Document Feeder)
Stacker
Place the scanner aligning the two front projection to the hollows on the bottom of the scanner.
Cover open lever
Pull this lever to open the ADF cover.
Paper chute cover
Open this cover and load the documents onto this part when scanning documents.
Side guide
Adjust these guides to the documents width for preventing skewed images.
Stacker
For using this part, pull it out | Buttons |
as shown in the figure.
→Documents are ejected from the ADF onto this tray.
*You can also use the scanner without the Stacker.
Buttons
[SCAN] button
Starts scanning.
[POWER] button
Turns on/off the power supply.
Power lamp 
Indicates the scanner status.
Blue | :Ready |
Blue (Blinking) | :Scanning |
Yellow | :Error |
Light off | :Power off |
Back Side
USB connector | AC adapter connector | ||
|
|
|
|
Seal: After installing ScanSnap Manager onto your computer, remove this seal to connect the scanner to the PC.
HINT | For the Document Specification, refer to the |
| “ScanSnap |
| Guide” stored in ScanSnap Setup |
| |
ATTENTION | The scanner turns on/off automatically, when you |
| open/close the Paper chute cover. |
| To turn off the scanner when the cover is open, |
| press the [POWER] button. |
ScanSnap