■Connecting the SCSI interface
When using the scanner with a SCSI interface, the following SCSI cable and SCSI card must be purchased.
•SCSI cable
Use a SCSI cable whose connector on the scan- ner side is the
It is recommended to use a cable of length 1.5 m or shorter.
•SCSI card
Find the recommended SCSI card information on the Fujitsu web site (FAQ).
http://www.fujitsu.com/global/support/computing/peripheral/scanners/scsi/ATTENTION | • When connecting the SCSI cable, turn |
| the scanner off. Be sure to connect the |
| SCSI cable first, and then turn on the |
| power of the scanner and PC. |
•In a SCSI daisy chain configuration, connect the scanner so that it is the ter- minated device.
1.Insert the SCSI cable into the interface connec- tor of the scanner until both sides click.
2. Connect the other end of the cable to your PC.
ATTENTION | Be careful not to bend the pins of the SCSI |
| cable when connecting to the scanner. |
3.Set the SCSI ID using the SCSI ID switch on the back of the scanner.
The SCSI ID is initially set to "5" at the factory.
If the SCSI ID of another SCSI device is set to the same ID, either change the scanner's SCSI ID or SCSI ID of the other SCSI device.
| ID No. | Description |
|
|
0 to 7 | Can be set as the ID |
|
|
8, 9 | Works with the factory default value |
| (SCSI ID = 5). |
When the scanner is turned on, the SCSI ID set is enabled.
4.Press the "I" side of the main power switch to turn on the scanner.
OFF ON
■When using VRS
When using the Kofax® VRS, you need to connect it to the exclusive VRS board with either the USB cable or SCSI cable.
1.If you use the USB cable, insert it into the inter- face connector (1) shown below.
If you use the SCSI cable, insert it into the interface connector (2) shown below.
SCSI ID Switch | VRS board |
2 1
2. Connect the other end of the cable to your PC.
5