Fujitsu fi-5950 ■Temporary error, ■Device alarm (Permanent error), AP-3

■Temporary error

Indication		Meaning

J0	The paper feeding stopped to protect
	jammed paper from damage.

U1	A paper feed error occurred.

U2	A multi feed error occurred.

U4	The ADF cover or the pre-imprinter
	cover is opened.
U6	The print cartridge is not set.

U8	One of the following error occurred:
	1.	The document sensors are dirty.
	2.	The stacker is full.
	3.	The Brake roller or Separator rollers
		are not installed properly.

The following shows the procedure for releasing of each of the temporary errors.

•"J0" or "U1" error

1.Remove the document jammed or stopped in the ADF.

(Refer to the fi-5950 Operator’s Guide "6.1 Clearing Document Jams" on the SETUP DVD-ROM.)

2.Confirm that the documents meet the paper specifications for scanning.

(Refer to fi-5950 Operator’s Guide "7.2 Docu- ment Quality" on the SETUP DVD-ROM.)

•"U2" error

Press the [Send to] button on the Operator Panel. The documents that were multi fed will be ejected.

•"U4" error

Close the ADF cover or pre-imprinter cover.

•"U6" error

This is a temporary error related to the Imprinter option (sold separately). For details, refer to the "fi-590PRF/ fi-590PRB Operator's Guide", "5 Error Message".

•"U8" error

1.Clean the document sensors

For details refer to fi-5950 Operator’s Guide "4.5 Cleaning the Transport path and the sen- sors".

2.Verify that the number of sheets ejected to the stacker is below stacker’s capacity, and that the Pick roller is not set for manual feeding.

3.Verify that the both rollers are installed prop- erly. For details, refer to fi-5950 Operator’s Guide "5.5 Replacing the Separator Rollers" and "5.6 Replacing the Brake roller".

■Device alarm (Permanent error)

Indication	Meaning

E0	Hopper or Stacker error

E2	Optical system error (front)

E3	Optical system error (back)

E4	The motor fuse has blown out.

E5	The lamp fuse has blown out.

E6	Operator panel error

E7	Trouble occurred in the internal memory
	(EEPROM).

E8	SCSI fuse has blown out

E9	Image memory error

EA	Imprinter error

Ec	Image memory error

Ed	SCSI interface or USB interface
	controller error

EF	Background switching mechanism error

E10	ROM error

E11	Cooling fan error

E12	Heater error

E15	Extended memory error

E16	Option board error

E17	The imprinter fuse has blown out.

E18	Sensor error

E19	LSI error

E1A	Troubles occurred in the communication
	inside of the scanner.

E1b	5-volt fuse has blown out.

When you encounter any alarm, turn off and on the scanner. If the alarm is still displayed on the Function Number Display, contact the store where you purchased the scanner or an authorized FUJITSU scanner service provider.