Fujitsu M4000/M5000 Installing the Bracket Kit (Optional)

Installing the Bracket Kit (Optional)

If additional attachment points are required to route the cables, the bracket kit can be installed. The bracket kit includes the following:

■Two (2) brackets

■Four (4) m5 screws

■Four (4) m5 cage nuts

■Ten (10) velcro strips (SPARC Enterprise M4000 Server)

■Fourteen (14) velcro strips (SPARC Enterprise M5000 Server)

These brackets can be used on the SPARC Enterprise M4000 server. And these brackets can be used on the SPARC Enterprise M5000 server using the Copper link cable.

1.Extend the rack stabilizer.

2.Slide the server out of the rack several inches for access to the rear of the equipment rack.

3.Position the cage nuts behind the threaded ears of the equipment rack and insert the two (2) screws through the bracket and rack ear (FIGURE 4).

Brackets should be positioned near the top level of the server or slightly below it.

Note – Brackets can be installed one per side, one only (right or left side), or two on one side, as desired for convenience in cable management.

14 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1041 • July 2007