TABLE 6 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID | Description | Workaround |
|
|
|
6515648 "Replumb Failedʺ error appears when dr@0:SB1::memory fails.
Once the DR operation is complete, it can be
plumbed up manually.
Example steps/procedure to re‐plumb the interface manually:
#ifconfig interface plumb xxx.xxx.xxx.xxx netmask + broadcast + up
#ifconfig interface group group‐name
6519290 Large amounts of I/O on swap devices can cause the system to appear hung by over welling the I/O system. The amount of I/O required can be generated through a number of ways, eg memory shortage, heavy use of /tmp etc.
6520990 Domain may cause a panic when deleteboard for kernel board by using Dynamic Reconfiguration (DR).
6522017 Domains using the ZFS filesystem cannot use DR.
6522433 After the CPU hardware error occurred, the fmdump(1M) command on the domain may display an incorrect faulty component.
6529714 Warning messages occur while trying to configure more than four X4447A‐Z or X1027A‐Z1 cards into one I/O Boat.
6530178 DR addboard command can hang. Once problem is observed, further DR operations are blocked. Recovery requires reboot of the domain.
6530288 Ap_Id format may not be shown correctly by cfgadm(1M).
#ifconfig interface addif xxx.xxx.xxx.xxx
This workaround assumes that the /etc/hostname.interface file is correctly configured for the IPMP group and does not need any modification. The IP addresses used in the example above should match what was previously used and what matches the
/etc/hostname.<interface> file.
Set the following to /etc/system and then reboot the domain:
set maxfastscan=0x2000
To mask this error, add the following entry to the /etc/system file.
set drmach:fmem_timeout = 30
There is no workaround.
Check system status on XSCF.
No workaround available at this time.
There is no workaround. Check availability of a patch for this bug.
None available at this time.
28 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1041 • July 2007