Fujitsu MAW3300FC, MAW3147FC, MAW3073fc manual Important Alert Items, C141-E235

Important Alert Items

Task	Alert message	Page
Installation	Damage
	1. When dismounting the drive which is mounted on the system while	5-16
	power is supplied to it.
	• The drive to be dismounted must be separated from the loop.
	Dismounting the drive which is not separated from the loop
	may cause an unexpected error.
	• If the drive is not separated from the loop, issue an LPB to the
	drive from the initiator in a primitive sequence of the order
	set.
	• It is recommended to stop the spindle motor prior to this loop
	separation operation. The spindle motor can be stopped by a
	START/STOP command. It takes about 30 seconds for the
	spindle motor to stop completely.
	• Then, dismount the drive using the drive
	mounting/dismounting mechanism, etc. of the system. If the
	drive is dismounted while the spindle motor is running, special
	care is required to avoid excessive vibration or shock to the
	drive. It is recommended to stop the operation once the SCA
	connector breaks off contact and wait until the spindle motor
	stops (about 30 seconds) before dismount the drive.
	• When storing or transporting the drive, put it in an antistatic
	case (Fcell). (Shown in Section 5.1).
	2. When dismounting the drive which is mounted on the system while
	power is not supplied to it.
	• Do not move the drive until the drive stops completely (about
	30 seconds if the spindle motor was stopped by a
	START/STOP UNIT command, and about 30 seconds after
	powering-off when the power was simply turned off).
	• Then, dismount the drive using the drive
	mounting/dismounting mechanism, etc. of the system.
	• When storing or transporting the drive, put it in an antistatic
	case (Fcell). (Shown in Section 5.1).
Diagnostics and	Data loss
Maintenance	When the SEND DIAGNOSTIC command terminates with the CHECK	6-4
	CONDITION status, the initiator must collect the error information
	using the REQUEST SENSE command. The RECEIVE DIAGNOSTIC
	RESULTS command cannot read out the error information detected in
	the self-diagnostics.
	Caution
	1. To avoid injury, do not touch the mechanical assembly during disk	6-5
	drive operation.
	2. Do not use solvents to clean the disk drive.

vi C141-E235