Usage Precautions, Ordering Information

MB15F74UV

■USAGE PRECAUTIONS

(1) VCCRF and VCCIF must be equal voltage.

Even if either RF-PLL or IF-PLL is not used, power must be supplied to VCCRF and VCCIF to keep them equal. It is recommended that the non-use PLL is controlled by power saving function.

(2)To protect against damage by electrostatic discharge, note the following handling precautions :

•Store and transport devices in conductive containers.

•Use properly grounded workstations, tools, and equipment.

•Turn off power before inserting or removing this device into or from a socket.

•Protect leads with conductive sheet, when transporting a board mounted device

■ORDERING INFORMATION

Part number	Package	Remarks

MB15F74UVPVB	18-pin plastic BCC
MB15F74UVPVB	(LCC-18P-M05)
	(LCC-18P-M05)

Page 23

Image 23

Fujitsu MB15F74UV manual Usage Precautions, Ordering Information, Part number Package Remarks

Contents

Pin plastic BCC LCC-18P-M05 FeaturesDescription Package PIN Assignments MB15F74UV Pin no Descriptions PIN Description MB15F74UV Block Diagram Recommended Operating Conditions Parameter Symbol Rating Unit MinParameter Symbol Value Unit Remarks Min Typ Absolute Maximum Ratings Min Typ Electrical CharacteristicsParameter Symbol Condition −40 C ≤ Ta ≤ 85 C Parameter Symbol Condition Value Unit Min TypCharge pump Vs V do V ≤ V do ≤ V CC − 0.5 Current rate Vs Ta R10 R11 R12 R13 R14 Functional DescriptionProgrammable Programmable Reference Counter Divide ratio Data settingDivide ratio R14 R13 R12 R11 R10 Divide ratio N11 N10 LD/fout pin state Phase comparator input FC IF, RF = Do IF, Do RFDivide ratio SW = Current value Status PS pin Power Saving Mode Intermittent Mode Control Circuit 100 Parameter Min Typ Max Unit IF-PLL section RF-PLL section LD output Phase Comparator Output WaveformFC bit = LD Output Logic Oscilloscope Controller Divide ratio setting RF-PLL input sensitivity vs. Input frequency Typical CharacteristicsCatalog guaranteed range Fin input sensitivity Input Oscin input sensitivityInput sensitivity vs. Input frequency Sensitivity Charge pump output voltage VDO MA mode Charge pump output current IDO mA FinRF input impedance Fin input impedanceFinIF input impedance Oscin input impedance Oscin input impedance PLL Reference Leakage PLL Phase NoiseReference Information Mkr x 439.99764 ∝s 50.0009 MHz Controller Application Example Part number Package Remarks Usage PrecautionsOrdering Information Fujitsu Limited C18058S-c-1-1 Dimensions in mm inches Package Dimension F0401 Fujitsu Limited

MB15F74UV

■USAGE PRECAUTIONS

■ORDERING INFORMATION

Part number

Package

Remarks

18-pin plastic BCC