Fujitsu MPF3XXXAH Signal assignment on the connector, DA1 PDIAG-, C Blid DA0 DA2, Dasp GND, Reset

5.1.2Signal assignment on the connector

Table 5.2 shows the signal assignment on the interface connector.

Table 5.2 Signal assignment on the interface connector

Pin No.	Signal	Pin No.	Signal
1	RESET–	2	GND
3	DATA7	4	DATA8
5	DATA6	6	DATA9
7	DATA5	8	DATA10
9	DATA4	10	DATA11
11	DATA3	12	DATA12
13	DATA2	14	DATA13
15	DATA1	16	DATA14
17	DATA0	18	DATA15
19	GND	20	(KEY)
21	DMARQ	22	GND
23	DIOW–, S TOP	24	GND
25	DIOR–, HDMARDY–, HSTROBE	26	GND
27	IORDY, DDMARDY–, DS TROBE	28	CSEL
29	DMACK–	30	GND
31	INTRQ	32	reserved
33	DA1	34	PDIAG–, C BLID–
35	DA0	36	DA2
37	CS0–	38	CS1–
39	DASP–	40	GND

[signal]	[I/O]	[Description]
RESET–	I	Reset signal from the host. This signal is low active and is asserted
		for a minimum of 25 μs during power on. The device has a 10 kΩ
		pull-up resistor on this signal.
DATA 0-15	I/O	Sixteen-bit bi-directional data bus between the host and the device.
		These signals are used for data transfer
DIOW–, S TOP	I	DIOW– is the strobe signal asserted by the host to write device
		registers or the data port.
		DIOW– shall be negated by the host prior to initiation of an Ultra
		DMA burst. STOP shall be negated by the host before data is
		transferred in an Ultra DMA burst. Assertion of STOP by the host
		during an Ultra DMA burst signals the termination of the Ultra
		DMA burst.

C141-E106-01EN 5 - 3