Fujitsu P7230 manual Self Test Messages on page 77 for more information, Video Problems

			T r o u b l e s h o o t i n g
Problem	Possible Cause		Possible Solutions
The system powers up,	You have a secured system	Make sure you have the right password. Enter the setup
and displays power on	requiring a password to load	utility and verify the Security settings and modify them as
information, but fails	your operating system.	accordingly. (See BIOS Setup Utility on page 27 for more
to load the operating		information)
system.
	Internal hard drive was not	Use the BIOS setup utility to try to auto detect the internal
(continued)	detected.	hard drive. If this does not work, contact Fujitsu Service and
		Support at 1-800-8FUJITSU.
An error message is	Power On Self Test (POST)	See the Power On Self Test (POST) messages to determine
displayed on-screen	has detected a problem.	the meaning and severity of the problem. Not all messages
during the notebook		are errors; some are simply status indicators. (See Power On
(boot) sequence.		Self Test Messages on page 77 for more information)
Your notebook	BIOS setup changes were not	Make sure you select Save Changes And Exit when exiting
appears to change	saved when you made them	the BIOS setup utility.
setup parameters	and exited the BIOS setup
when you start it.	utility returning it to
	previous settings.
	The BIOS CMOS battery has	Contact your support representative for repairs. This is not
	failed.	a user serviceable part but has a normal life of 3 to 5 years.
Video Problems
The built-in display is	The notebook is set for an	Pressing [F10] while holding down the [Fn] key allows you
blank when you turn	external monitor only.	to change your selection of where to send your display
on your LifeBook		video. Each time you press the combination of keys you
notebook.		will step to the next choice. The choices, in order are: built-
		in display only, external monitor only, both built-in display
		and external monitor.
	The display angle and bright-	Move the display and the brightness control until you have
	ness settings are not adequate	adequate visibility.
	for your lighting conditions.
	Power management timeouts	Press any button the keyboard, or move the mouse to
	may be set for short intervals	restore operation. If that fails, push the Suspend/Resume
	and you failed to notice the	button. (The display may be shut off by Standby mode,
	display come on and go off.	Auto Suspend or Video Timeout)
	The notebook is set for S-	While holding down the [Fn] key, click on the [F11] key to
	Video display only.	toggle the S-Video display off.
The notebook turned	Power On Self Test (POST)	Contact your support representative.
on with a series of	has detected a failure which
beeps and your built-	does not allow the display to
in display is blank.	operate.
The display goes blank	The notebook has gone into	Press any button on the keyboard, or move the mouse to
by itself after you have	Video timeout, or Standby or	restore operation. If that fails, push the Suspend/Resume
been using it.	Hibernation modes because	button. Check your power management settings to adjust
	you have not used it for a	the timeout values to better suit your operation needs. (See
	period of time.	BIOS Setup Utility on page 27 for more information)
	The power management	Press any button on the keyboard, or move the mouse to
	timeouts may be set for very	restore operation. If that fails, push the Suspend/Resume
	short intervals and you failed	button. (The display may be shut off by Standby Mode,
	to notice the display come on	Auto Suspend or Video Timeout)
	and go off.

75