72
2.2 Inserting/Ejecting the Data Cartridge
Handle the data cartridge properly, refer to "3 About the Data Cartridge" (Jpg.73).
How to insert
Pull the front door up and insert the data cartridge slowly into this product with the arrow mark facing
up and the label panel facing you. When the data cartridge is fully inserted, it starts loading
automatically.
`If you want to perform backup or restore operations immediately after inserting the data
cartridge, wait until the data cartridge is completely loaded (until the ACTIVITY LED finishes
blinking and turns off).
How to eject
Check that only the ACTIVITY LED is off, and press the eject button.
Put the ejected data cartridge in the cartridge case to store.
`Eject the data cartridge when this product is not operating the data cartridge (when the
ACTIVITY LED is turned off).
`Depending on the backup software, the data cartridge cannot be ejected using the eject
button (NetVault, etc.). In this case, pressing the eject button does not eject the data
cartridge. Eject the data cartridge by operating the backup software.
`When this product is turned off, the data cartridge cannot be inserted or ejected.
`To avoid damaging this product and the data cartridge, note the following points.
• Do not use too much force.
• Insert the data cartridge straight in the correct position in the c orrect direction.
`When ejecting the data cartridge, do not stop it or push it back in. Also, do not pull out
the data cartridge before it has fully ejected. Doing so may cause product failure.