Furuno B042-004, B042-016, B042-008 manual Thru-hull mount water temperature sensor T-02MSB, T-03MSB

1. MOUNTING

Thru-hull mount water temperature sensor T-02MSB, T-03MSB

•Select a suitable mounting location considering the following points:

•Select a mid-boat flat position. The sensor does not have to be installed perfectly perpendicular; however, the location should not be such that the transducer may be damaged when the boat is dry-docked.

•Locate away from equipment which gives off heat.

•Locate away from drain pipes.

•Select a location where vibration is minimal.

T-02MSB T-03MSB

Sensor Holder

Sensor
cable			Locknut
Locknut
Washer
Gasket			Locknut
φ 21 mm			Washer
			Gasket
		φ 25 mm
Coat with
sealant.
		Coat with
		sealant.
Mounting procedure				Plate thick-
		Holder Guide		ness within
1. Drill a hole of 21 mm in diameter in
				25 mm
the mounting location.
	Mounting procedure
2. Pass the sensor cable through the
	1. Drill a hole of 25 mm in diameter in the mounting
hole.
		location.
3. Pass gasket, washer and locknut
	2. Coat holder guide with high quality sealant, and
onto cable in that order.
		pass gasket, washer and locknut onto holder
4. Coat the sensor flange with high
		guide in that order and then tighten the locknut.
quality sealant and then fasten the
	3. Set the sensor holder to the holder guide from
sensor with the locknut.
		inside the boat and then tighten the locknut.
(Torque: max. 59N·m)
	4. Launch the boat to check for water leakage
5. Launch the boat to check for water
		around the sensor.
leakage around the sensor.

Assembling thru-hull water temperature sensor T-02MSB, T-03MSB

1-5